Categories
Shop By Brand
Blowout Specials
More Information
|
|
|
 |
|
|
|
Frequently Asked Questions for Custom Copper Sinks
How are the custom copper sinks constructed?
Each sink we make is individually made by hand. Sinks are made from 20-32
ounce copper in one piece, shaped sort of like a fat cross. They are bent
around a form to bring the sides together, and the corners are then individually
hand-soldered. (We solder our sinks using lead-free solder by hand the old fashion
way they did many years ago. One of our competitors copper brazes his sinks in the
interest of modern manufacturing efficiency! They didn't know how to braze 200
years ago! The hole is cut and formed to accept the drain assembly, and the lip is
added if the sink is a self-rimming unit. A birch plywood box is then constructed
for the sink to rest in. (Copper is very soft, so the box is necessary for added
strength. You can literally stand in the sink and not damage it.) Beware of
competitors who try to tell you this box isn't required; you'll be disappointed in
the long run. In most installations it's not even seen!
What are the size limitations?
There are no real limitations, just practical ones. We can get copper sheets up to
48 inches wide, which allows us to make a sink with the sides and bottom (front to
back) totaling 46 inches, leaving 2 inches for the top lip. The sink in our kitchen
is 30" in width, 20" front to back, and 10" deep. Drain placement can be anywhere on
the bottom of the sink, although it must be at least 6” from any edge of any bowl
for proper drainage. Unlike some other manufacturers, Exoticsinks sinks have no
unsightly creases on the bottom of the sink to get the water to drain. Our sinks
all gradually slope towards the center.
Do you make double or triple sinks for the kitchen?
Yes, we can make a double and triple sinks; we would need the overall dimensions of
the unit as well as the size of each bowl. The bowls can be different widths. It
all depends on your application and your imagination!
Can I install a disposal in my Exoticsinks kitchen sink?
The sink will accommodate disposal units, however you must be sure you have the
clearance under the sink (especially if you order a deep unit) to accommodate the
disposal and the associated plumbing.
Are drain assemblies available?
Yes, we currently stock brass and copper units in six different finishes which
complement our sinks beautifully. Other finishes can be special ordered. The hole
will accommodate any standard kitchen stop and waste drain assembly. We also carry
disposal trim rings in similar finishes.
Will the sink stay smooth and shiny?
Yes and no... Our copper sinks thrive on neglect; these sinks are designed to look
old, (and will) from the minerals in tap water in a very short period of time;
usually only a couple of weeks. Since copper is soft, they can eventually get dents
and dings with normal use. If you're after a smooth and shiny copper sink and want
it to stay that way then maybe these sinks aren't for you. If however you are
looking for something to go with your antique farmhouse, Victorian restoration or
if you just like the look of old copper, then you have found your sink!
How do you clean the sink?
The sink can be cleaned with any readily available copper and brass cleaner which
we include free with the purchase of a new sink. Brasso and Wrights Copper Cream
are two excellent cleaners. Additional containers are also available.
More Questions?
If you have additional questions or concerns, please call us toll free at
(800) 600-7210, e-mail us at info@exoticsinks.com, or write to us at the
address below. We're here to help!
|
|
|
|
|
|
